Refrigerators and freezers
When a refrigerator runs without cooling, the condenser coils are usually the first stop. In city apartments those coils sit under the unit or behind a kick plate, packed with pet hair and dust that make the compressor work twice as hard. Next the tech listens for the evaporator fan behind the freezer panel, because a dead fan leaves a freezer cold and the fresh food side warm. If frost has built up on the evaporator coil, the defrost system is next: heater, defrost thermostat and control board, each checked for continuity with a multimeter. Repeated clicking with no compressor hum often means the start relay or overload has failed.
Washers
A washer full of standing water almost always comes down to the drain path. The tech checks the pump filter for socks, coins and hair ties, then tests the drain pump motor itself. If the machine will not start or spin, the lid switch on a top-loader or the door lock assembly on a front-loader is a common culprit. Loud banging during spin points to the suspension: worn shock absorbers, springs or a cracked spider arm on the drum.
Dryers
An electric dryer with no heat usually has a blown thermal fuse or dead heating element, while a gas dryer with no heat often has a weak igniter or bad valve coils. A drum that sits still suggests a broken belt, while squealing or thumping points to worn drum rollers or the idler pulley. What people tend to miss is that a thermal fuse fails for a reason, and the reason is usually a blocked vent. In high-rises with long shared vent runs, the tech will check airflow at the exhaust before calling the job done.
Dishwashers
Water pooling in the tub starts with a check of the filter and drain hose, then the drain pump. If the unit hums but never fills, the water inlet valve and its solenoid get tested. Dishes that come out cold and wet usually mean a failed heating element or high-limit thermostat.
Ranges, ovens and cooktops
When a gas oven clicks without lighting, the hot surface igniter has usually weakened and no longer draws enough current to open the safety valve. The tech checks that with a clamp meter, and may use a manometer to confirm gas pressure at the regulator. Electric ovens that heat unevenly often have a broken bake or broil element, and ovens that run hot or cold usually have a drifting temperature sensor, checked against the resistance chart on the tech sheet.
Microwaves
When the light and turntable work but the food stays cold, the magnetron, high-voltage diode or capacitor is a likely suspect. A totally dead microwave often has a blown internal fuse triggered by a bad door switch. Never open a microwave yourself: the high-voltage capacitor can hold a lethal charge long after the unit is unplugged, and a trained tech discharges it safely before touching anything.
